Ch340G Driver Extension Is

Ch340G Driver Extension Is

If you run into any issue like this: It means that the CH340 USB driver extension is blocked by Mac.

In order to allow the CH340 USB driver, go to Mac Security Privacy and select Allow as shown below: Step 2: Software Installation In order to begin, you must download the software.

Afterwards, find the file, unzipping as needed, and find the candle.dmg file inside.

Candle will launch directly from this, and youre good to go Step 3: Configuring Candle Connect your CNC via the USB cable and start Candle.

Ideally you should see something like the screenshot below: The red Alarm state in the status box is actually good The 3018 and 4030 PROVer CNCs are fitted with limit switches and by default has Homing enabled.

Until a Homing Cycle has been run it will be in an Alarm state as it has no idea where the spindle is and will accept very few commands.

You can also get out of this state by clicking on the padlock icon in the Control section of Candle to unlock the machine.

If you are not seeing the above image, you may see the following image below: If its the second image, then Candle cannot find your router.

Simply select the ServiceSettings option from the top menu and you should see the settings menu: Check that the Baud: value is 115200, if not change it, then Click on the connectionPort dropdown menu and select the COM port your router is connected to, there should not be many so if necessary try them each in turn.

Click on OK and you should see first screen shown above, if not select the next COM port and retry.

If all else fails check the USB cable connection to the router, as well as see if the Emergency Stop button is pressed (It shouldnt be) and retry.

Before proceeding any further, check some settings: the Machine Information section setcheck the following: Rapid Speed should be set to 2000 Spindle Speed Min should be set to 0 Spindle Speed Max should be set to 10000 Laser Power Min Should be set at 0 Laser Power Max Should be set at 10000 And hit OK.

Ch340G Driver For Mac